Earlex HV2900 Manuel d'utilisateur télécharger pdf (Page 6)

CAUSE ACTION REQUIRED

Paint too diluted Add undiluted paint

Paint output too high Reduce the paint output by adjusting the Paint Flow Adjuster (9)

Moving too slowly Increase speed of application

Spray Trigger held for too long Release Trigger sooner

Spray Gun too close Increase the distance between the Spray Gun and the work

surface

Paint too diluted Add undiluted paint

Paint output too low Increase the paint output by adjusting the Paint Flow Adjuster (9)

Moving too fast Reduce speed of application

Spray Gun clogged Clean the Spray Gun

Spray Gun too far away

Move the Spray Gun closer to the work surface

Paint too thick Add thinner

Fluid Tip clogged Clean the Fluid Tip (5)

Pick-up Tube clogged Clean Pick-up Tube (11)

Air Hose split Replace air Hose (13)

Grainy paint Filter the paint

Paint Container almost empty Refill Paint Container (12)

Spray Gun at an angle Check that the Pick-up Tube (11) is pointing towards the paint

Air inlet blocked Check the condition of the Filter (14) and clean if necessary

You move your wrist Move your forearm instead

Either too much or not enough paint Use the Paint Flow Adjuster (9) to control the flow

PROBLEM

The paint drips onto item being

painted

Paint is too thin or irregular

No paint being released

Too much paint in an area

Application

ROUBLESHOOTING

SPRAY GUN

1 2 3 4 5 6 7 8

Pas de commentaire

Earlex HV2900 Manuel d'utilisateur Page 6