Earlex HG1500 Manuel d'utilisateur télécharger pdf (Page 3)

#$&(#"

Before starting work it is advisable to test

the work surface for the ideal

temperature to use. The table below

gives an indication of the likely heat

settings required but always start with

the low heat setting. All applications, with

the exception of removing paint from

window frames, can be performed

without using a nozzle, however for best

results nozzles are recommended.

";FF82?

The gun is supplied with two different

shaped nozzles, which can be used as

follows:

;:02:@>.@;>

";FF82

●

Directs a

concentrated heat

flow to the work

surface.

●

Ideal for removing

paint in awkward

corners, crevices,

mouldings,

beading or

architraves.

8.??$>;@20@6;:

";FF82

●

Deflects the heat

away from glass

or other fragile

areas.

●

Ideal for window-

sills, ledges,

frames and

skirting boards.

&29;B6:4<.6:@42:2>.8

;:;@52.@@52<.6:@3;>@;;8;:4.?

@56?C688/A>:@52<.6:@9.76:46@

163360A8@@;>29;B2

1.Choose the required nozzle and fit

onto the heat outlet.

2.Hold the gun with nozzle approximately

50mm (2”) from surface of paintwork.

3.Starting with the low heat setting, move

the gun slowly backwards and forwards

until the paint blisters and bubbles.

4.Immediately remove the paint with a

scraper or shavehook.

5.Aim to heat the paint just ahead of the

scraper so that you can develop a

continuous action.

&29;B6:4<.6:@3>;9C6:1;C3>.92?

+&""G8.??0.:/>2.72.?68E

C52:52.@21

1.Use the glass protection nozzle.

2.Ensure the nozzle is facing the correct

way to deflect heat away from the

glass before you switch on the heat

gun.

3.Rotate the gun/nozzle 90º as you move

to horizontal or vertical bead (take care

it could be hot!).

4.Paint can be removed by using a

shavehook and/or a soft wire brush.

!.6:@2:.:02

Always allow the machine to cool down

(before storing) and disconnect from the

power supply. The heat gun should be

cleaned before being stored away by

wiping over with a clean damp cloth. #

"#()'! ' Ensure that the

ventilation slots are not blocked.

(>;A/82'5;;@6:4

3.<>;/829;00A>?.8C.E??C6@05;33

@52A:6@699216.@28E.@@529.6:?

!EA:6@3.68?@;C;>7

Check the fuse in the plug is sound and

rated 13 amps.

If an extension cable is used it must be

fully unwound and rated at least 10

amps capacity.

3

;:02:@>.@;>:;FF82

8.??

<>;@20@6;::;FF82

G84

G89

;C 645

Welding plastic Paint stripping

Bending plastic Defrosting pipes

Heat shrinking

plastic

Removing vinyl

floor tiles

Soldering

Lighting BBQs

'A442?@21&.@6:4?

1 2 3 4

Commentaires sur ces manuels

Pas de commentaire